EWP®115 Nylon Kit – Remote Electric Water Pump (12V)

The EWP^®115 Nylon 12V is available for purchase in following options:

• Pump Only (Part DC8125)
• Kit (Part DC8025)
• Combo with Controller (Part DC8930)

The EWP^®115 pump is suitable for small, medium, large, high-performance and 4WD vehicles. It’s a performance product that improves engine cooling control and capacity whilst giving you more power and torque and improved fuel economy.

The EWP^®115 is a practical alternative to the mechanical belt-driven pump or fitted as an auxiliary pump. Mechanical belt-driven water pumps run directly off the motor and sap engine power … the EWP^®115 is hardwired into your electrical system, by-passing the engine and releasing up to an additional 10kw (13hp). Our EWP range are also extensively used in Intercooler Applications.

Kit Includes

• 1x EWP®115 Nylon 12V
• 1x EWP® Basic Wiring Harness
• 2x Hose Clamps
• 1x RED – Wire Joiner
• 1x RED – 6mm Ring Terminal
• 1x RELAY – 12V 40 Amp 5 Pin w/ Resistor Protection
• 1x SCREW – SELF TAP 8X3/8 BZ

Technical specifications

• Voltage: 12 Volt Pump
  
• Operating voltage: 3V DC to 15V DC
  
• Maximum current: 10A @ 13V
  
• Flow rate (max): 139 L/min (36.7 US gal/min) @ 13V DC
  
• Operating temp.: -40° to 120°C (-40° to 248°F)
  
• Pump design: Clockwise centrifugal with volute chamber
  
• Pump weight: 920 grams (2.03 lb)
  
• Pump material: Nylon 66 - 30% Galss Filled
  
• Burst pressure: 500 kPa (72.5 psi)
  
• Seal: Ceramic face seal
  
• Self priming: No, none of our pumps are self-priming
  
• Fits hose sizes: 35mm to 51mm (1⅜” to 2”) Push on fittings
  
• Push-on fitting size:
  EWP inlet & outlet 38mm
  
  • with 3mm Sleeve (DC8510) 44mm
  • with 6mm Sleeve (DC8511) 51mm